Rv Slide Awning Adjustment

Roller should now be free of mounting hardware.

Rv slide awning adjustment.

How to adjust the tension on an rv slide out awning step 1. Remove end cap or mount. The roller has a spring in it. Step up to the awning and clear out any leaves or twigs from the awning seam.

I have dometic slide toppers on my allegro 35qba that are pooling water. Usually takes 2 people. Lower the rear leg detach it from the rv and prop it up on the ladder like we did for the front leg in the previous steps. Facing the awning the arm on the left has the rewind spring.

Be very careful there is a lot of tension on the arm. So reattach the front leg to the side of the rv and raise it up a bit. Loosen the left arm pull it out just enough to clear the slide. Level the rig using its jacks and level system.

I ve searched everywhere for instructions on how too tighten them but found nothing other than installation or awning fabric replacement instructions. Park the rv and set the brake. Put a cotter pin in the hole. Now we need to do the same for the other awning leg.

Run slide in about 12. An rver asks gary bunzer the rv doctor why the awning on his recreational vehicle will not retract evenly and what he can do to f. Slide topper tension adjustment. With great ease turn the arm counter clock wise.

Is there a way to adjust the tension on the end of. You should now be at the rear of the awning facing the front. Make sure it will not fall out. Place the step stool near the lip.

Look for the pin hole near end of roller. One turn may give you the desired tension. If not turn arm one more turn. Subscribe now for our next rv living experience sharing.

Dear chris the awning over my slide out is sagging on one end the other end is tight as both ends should be.